Knowledgebase
Protecta Support Site > Help Desk > Knowledgebase

Ask a question:


No measurement values are being transmitted to the SCADA system

Solution

 

In order to transmit on-line measurement values from the protection device to the SCADA system, the Line Measurement function block shall be active and its parameters shall be properly set. A short summary about setting those parameters can be found in the attached document.  

 

Attachments:
mxu_v1.0.pdf mxu_v1.0.pdf

 
Was this article helpful? yes / no
Article details
Article ID: 24
Category: Europrot+ Communication
Date added: 2019-09-03 12:50:43
Views: 34
Rating (Votes): Article not rated yet (0)

 
<< Go back

Copyright by Protecta LTD 2012-2015 - powered by HESK