Knowledgebase
Protecta Support Site > Help Desk > Knowledgebase

Ask a question:


Error message on web browser after parameter change

Solution

In some cases the user may see error messages in the web browser after a parameter change. The most common reasons are the following:  

 - the browser flash has not been cleared yet

 - another device had previously the same IP-address and its webpage was also checked by the same PC

 - the web browser is out of date

In the first two cases the solution is to clear the flash with Ctrl + F5 buttons. In the third case a browser update will likely solve the problem.

 

 

 
Was this article helpful? yes / no
Article details
Article ID: 34
Category: Europrot+ HMI (LCD & WEB)
Date added: 2019-11-07 13:37:03
Views: 21
Rating (Votes): Article rated 5.0/5.0 (1)

 
<< Go back

Copyright by Protecta LTD 2012-2015 - powered by HESK