 |
We would like tu use IEC 61850 communication and also SPA bus at the same time. Do you have any solution for this kind of combination?
The solution is the CPU+/1301 module. One port Ethernet and seri... |
|
 |
In order to transmit on-line measurement values from the protection device to the SCADA system, the Line Measurement function block shall be active and its parameters shall be properly set. A ... |
|
 |
Ha szeretnénk mért értékeket továbbítani a SCADA felé, akkor a Vezetéki Mérési Funkciót aktiválni kell majd helyesen... |
|
 |
If you have communication problems with IEC 61850, please check first the following common reasons:
1) The IED name must be different than TEMPLATE and it must start with an alphabetic character; num... |
|
 |
Ha az IEC 61850 kommunikáció nem működik, a következő gyakori okokat ajánlott leellenőrizni:
1) Az készülék neve nem lehet TEMPLATE és nem ... |
|
 |
There are several ways to change between setting groups in EuroProt+ devices. Attached is a short summary, how the different channels can be used.
|
|
 |
Az EP+ készülékek különböző lehetőségeket kínálnak a paraméter készletek közötti átváltásra. A csa... |
|